resumo
Sintered hardmetals are very hard materials that are usually machined using diamond grinding wheels and electro-discharge machining. Dry cutting with super-hard cutting tools like cubic boron nitride (c-BN), polycrystalline diamond (PCD) and chemical vapour deposition (CVD) diamond is an ecological alternative to reduce operation times and, therefore, to improve the productivity. In the present work, cylindrical forging dies of WC-27 wt.% Co hardmetal grade were turned at fixed operating parameters (cutting speed = 15 m/min; depth-of-cut = 0.2 mm; feed rate = 0.03 mm/rev.) using CVD diamond tipped hardmetal inserts. Commercial PCD and c-BN inserts were tested for comparison. The cutting tool behaviour was studied in terms of both the tool wear and the finishing quality of the workpiece. The tool damage was evaluated using a special probe for edge roughness evaluation, together with scanning electron microscopy observations. The CVD diamond tools survived the task showing slight cratering, whereas flank wear was the main wear mode for the other superhard tools. Amongst all the tested tools, PCD presented the worst performance in terms of tool wear and workpiece surface quality. Furthermore, the operation time was reduced to one tenth with respect to conventional diamond wheel grinding. (C) 2002 Elsevier Science B.V. All rights reserved.
palavras-chave
CUTTING TOOLS; MECHANISMS; CARBIDE
categoria
Materials Science
autores
Belmonte, M; Ferro, P; Fernandes, AJS; Costa, FM; Sacramento, J; Silva, RF
nossos autores
